Sunday, December 7, 2014

Fabrication - Welding practices and rotisserie I

I'm on a roll, as here comes yet again an update!

This week we achieved a start of a rotisserie (for the frame work), installed an exhaust fan and shop computer, made a holster for the welding gun and generally "dicked" around in the garage.

After the first welds in the garage, it was obvious that an exhaust fan would be needed.
So we drilled a 100 mm hole in the wall, stuck a pipe through it and mounted a fan to it. Might have to add some ducting to it as to gather the fumes more efficiently.